Innokin GoMax Tube Starter Kit review-Remarkable Clouds

The Innokin GoMax Tube comes from a brand name that is famous for starter systems. There’s the throw away GoMax container, setup for Primary to Lung (DTL) vaping.

It’s a disposable reservoir, on top of a rechargeable battery power. It is possible to fill the reservoir along with your desired e-liquid, and when the coil eventually can burn out, you chuck the tank and obtain a replacement.

The Tank

There is a large (9mm) bore mouthpiece, though it is just 5mm broad over the coil. There’s a slip top fill up with silicone membrane covering the load port. Airflow realignment is via a cyclops design airflow engagement ring on the bottom. When I first acquired this I was thinking it wasn’t adaptable as it’s quite rigid and consists of the same PCTG as all of that other container so it really blends in.

Satisfying is pretty simple, and also the resistance around the slide fill is still nice and tight even though utilizing it for some time.

However that silicone seal can be a pain, despite the fact that it’s true that it halts e-fluid escaping if you knock it over whilst filling up, I did often find that e-fluid would get trapped and bubble at the top after I was filling up it due to the silicone closing round the conclusion of my jar.


Completely wide open is really fully open, this can be a very loosened DTL vape. In the event, you don’t fancy quite so much airflow you can progressively shut it right down to discover your wonderful spot, for DTL I discovered that about halfway shut provided the very best mixture of the flavour of clouds. For what is basically a stock coil, I found that this cloud production was pretty remarkable.


The Plex 3D Mesh coils from Innokin are really tiny taste bangers. It’s a relatively cool vape, but really precise and great at spitting out your different flavor notes in your e-water.

It’s good enough which I was happily able to use it as my primary DTL product, gives a fantastic taste, and is also really user-friendly and acquire on with.


Product Name: GoMax Tube
Material: Stainless Steel
Battery: 3000mAh/3.7V
Capacity: 5.5ml
Tank Resistance: 0.19Ω(60-80W)
Voltage Range: 3.3V-4.2V
Cut Off Time: 10sec
Max. Output Current: 30A
Resistance Range: 0.13-3.5Ω
Thread Type: 510
Charging Current: 5V/2A


1 x Innokin Gomax Tube 80W Mod
1 x Innokin Gomax Disposable Tank
1 x MicroUSB Cable
2 x User Manuals

Now you can find it in our store.

Click here to see:   Innokin GoMax Tube Starter Kit

Now you can get it from AVE40 which provides Quality Vape Products which is a trusted Vape Wholesale Supply by VapeShops Owners.

Wholesale Inquiry:

Leave a Reply

Your email address will not be published. Required fields are marked *